Electric Tooth Brush Masterbater

instructions Stiftui

You will need: (all parts are with 1.5 cm seam allowance)

material:
1x outer part
23x23cm 2x 13x23cm
2x inside flap part
paper bag 1x 11x22cm 8x23cm
2x zippered pocket 7.5 x17cm
1x RV-delusion 6x11cm

fleece (I have floor mat verwedet from Aldi)
1x outer part 20x20cm
2x flap part 8x19cm

Accessories:
1x zip (RV) of at least 14cm
1x Continuous Zipper (spiral) approx 95cm (only half is used)
1x slider for continuous zipper
2x rubber band 16cm, 2cm wide

Part of the RV bag inside out and paint the center 2cm away from the upper edge of a 14cm long line. Then still paint on a line 3cm from the top edge and close to the whole rectangle (1 cm height).

The zip pocket on the right place at the right center of the outer material, so that the distance cm from the upper edge of exactly 1.5. The piece of fabric stuck and use this guide to one zippered pocket.

It should look like now. take

from behind

A flap part and place the smaller middle ground cloth on the wrong side and pin. Then turn around.

paint in the middle of a line. Here, then, the rubber is sewn to the pins.

produce a Post-It with the help mark. These seven strokes exactly 1.2 cm apart to paint. The Post-It placed so that the two outer lines are each 2cm from the edge (ie middle)

on the rubber band all 2cm paint a stroke. This will be stitched later. (The loops are designed for thick crayons. In thin might make only 1.5 cm. Before testing, since not all the same stretch rubber on the sides you have won the 2 cm distance To make place for the seam allowance)

The Post-It as far away from the line that the rubber is perfectly in line and you can use the paper as a stop.

The rubber insert in the margin. The first marker should now coincide exactly with the Post-It flag. The rubber sew firmly. But I always close with a 3x normal straight stitch over it and then another half way back, that the thread end is located in the middle. Then it does not disintegrate as fast.

together, then pull the rubber to form a loop, the second Rubber marker and the Post-It-mark at the same height. The rubber sew as described above.

Just keep going until the gum is sutured kompett.

work the other part as well.

two flap parts put right sides together and sew around it once. Not on the fleece to sew, but just wide. One long side open and let the rubber several times back and sew.

It should look like now.

The two closed corners cut up the seam.

The flap part contact and thin-edged stitch (be careful that you do not the rubber loops mitfasst) If the fabric still cut curl handle just before the stitch a bit. The turning overcast opening and closing simultaneously.

The piece of fabric for the paper bag neaten on a longitudinal edge ...

fold ... and two times to stitch parallel to the edge. It can also be folded twice.

The bag lay on the inner fabric and finish edges around to fix it. Now you can still share the bag at will, so that you have not only a great time, but several small ones. I have shared the bag, just in the middle. Anyone who wants can also to the other inside to sew a bag. This time, possibly across and not along.

Now the final part with the flap serged seam up the middle to put the material inside, so that the edges are aligned.

Place the fabric over and above other women stuck.

one stitch (1.5 cm). sew again several times over the rubber.

It should look like now. The flap can move freely.

The flap put to one side.

Place the outer fabric on it. I lay it down so that the RV-Täsch on the opposite side as the paper's subject. One can also make both subjects on the page.

put together All around the two substances. Here, the flap mitfassen not

single stitch around. The opening can turn the bottom half open. Overcast and the corners cut off (except the opening at the turn).

contact the case. Insert

By the turn of the great opening piece of fleece and smooth out.

So it now looks from the outside.

close the opening turn. This simply fold the fabric to the inside.

Once around absteppen.Dabei is the turn of opening closed. Experienced Closer 'ability to save the step and stitch the bag until the large RV is sewn. Then you outside later than two seams on each other.

is now inside festgesteppt next to the door nor the fleece. Always close the door to one side and feet wide next to sew. The door to the other edge over and stitch presser foot wide there as well.

So the now looks from the outside.

the endless RV down onto the seam next to the door (Left side on the fabric). Narrow-edged sew from the outside. The RV-teeth facing up. On both sides, only to flap stitching sewing (see needle). Edging is a very helpful (see next photo)

at the corners: just sew to the corner. The needle can be stuck ..

... this case 90 °, adjust the RV back to the edge and continue sewing. watch

on the flap up, that they can not mitfasst. I simply bent a little.

Done. Below is sutured to the RV also stitching. Thread

the slider to the beginning and the end and pull. Be sure that the corners of the Mäpchens on the rack. Is that not the case, you have the slider slightly to settle once and thread.

The piece of fabric for the RV-end facing the center and fold easily inclined to sew opening.

turn and strike the edge.

The RV-ends on the same length, sew a few times about it, so he does not come loose. The RV-part pull over and stitch edged narrow around. About the RV several stitches.